Rear cover apart is first, then the front cover open, carefully on the Board and key board connected by cable to pull out, drive motor with a electric lens, lens sticking out. You can see, the lens out, and the front cover is not open. Gently to open at a touch. The front lens ring is made of hot-melt adhesive. Repair air duct blow will be when you can easily get it off. After winning component that you can see the lens cover plate with two screws, remove the screws you can take down the entire bracket components, we see there is a spring in the page, to open the page. Hand slide Springs, plates can be normal on/off, determine page trouble-free transmission devices, spring only in use for some time after the rally enough, take the lens out of the machine when not opened properly.


Treatment method is the spring cut two rings, and then bent into its original form. Button up completely normal after the test. Then the second failed, touch key is not sensitive.

From apart and checked it is a light-touch buttons, white paper with a stainless steel sheet, touching the points on the line, just a white film opened, with a blade in line of contact and few scratch on stainless steel sheets to the.